Automobiles it

2024-08-28 13:04:43

Prominent Listing

4 Photos

Aurora 7500 compound turbo kit

Low mile 7500 compound turbo kit in good condition

Parts & Accessories - Halliday, ND

$1,000 OBO

2024-09-06 17:11:27

3 Photos

Mopar high performance 318 V8

This engine is in a combine and is a very strong 318 that came from the factory with high performance cam. Buyer would have to either buy the engine and remove it

Parts & Accessories - Ryder, ND

$1,500 OBO

2024-09-06 16:20:41

Remanufactured Transaxle Assembly, 42LE Mopar Part #R4797840AF. 1993-1996

Remanufactured Transaxle Assembly, 42LE Mopar Part #R4797840AF Transaxle Assembly, 42LE Condition: New SKU: R4797840AA Weight: 261.60 Pounds Fits: 1993-1996 Dodge Intrepid; 1994-1996

Parts & Accessories - Glendive, MT

$2,295 OBO

2024-09-06 08:01:02

Turbo 350

THM 350 RWD short shaft Came out if 72(?) Nova Has shift kit and roughly a 2800 stall Dont know a lot about history. I did ride/drive the car before it got pulled. Shifted frim n fast Got

Parts & Accessories - Dickinson, ND

$800 OBO

2024-09-06 05:58:46

2 Photos

Chevy 4x4 pickup front drive shaft

Removed from a 1994 Chevy 2500 Drive shaft had maybe 1000 miles when the transmission went out and the pickup got parted out. Very good condition, no play

Parts & Accessories - Kief, ND

$150

2024-09-06 04:22:08

Eaton posi for GM 14 bolt 10.5" rear end

Basically new, maybe a few thousand miles on it, worked perfectly, only selling because it's extra after doing some rear end work. Stored in original packaging

Parts & Accessories - Mandan, ND

$600 OBO

2024-09-05 20:49:35

3 Photos

350 chevrolet chevy sbc crank crankshaft

good never cut polish it and install it is a cast piece

Parts & Accessories - Beulah, ND

$50 OBO

2024-09-05 20:31:34

2 Photos

Engine for saleTore it down to rebuild it many years ago. Been sitting in heated s

hop ever since.far as I know all parts are there. if memory serves me right, was not much wrong with the motor wouldve

Parts & Accessories - Alamo, ND

$1,000

2024-09-05 14:59:21

3 Photos

Jeep CJ dana 44 rear axle

This is a tapered shaft rear dana 44 axle. Has been gone through (prior to me acquiring it) with new brakes, bearings etc. Approx 53" from backing plate to backing plate. The

Parts & Accessories - Detroit Lakes, MN

$350

2024-09-05 08:04:24

2 Photos

Ford Powerstroke 6spd manual 7.3!

6 position chip for a Ford 7.3 powerstroke diesel with a manual 6 speed transmission. Used one summer then I sold the pickup worked great! Asking $50 I can bring

Parts & Accessories - Tuttle, ND

$50

2024-09-05 07:54:49

2 Photos

2 Strut/ coil spring/ mount assembly bought for a 2002 Pontiac Aztec might fit oth

er vehicles. There new in box never been used. Heres the site bought them from https://www.rockauto.com/en/parts/ultra-power,172113,strut+/+coil+spring+/+mount+assembly,151

Parts & Accessories - Watford City, ND

$25 OBO

2024-09-04 23:00:05

1969 Chevelle. Front end rebuild kit

Have a new front end kit for gm cars will trade for whatever , paid 200 for it

Parts & Accessories - Rhame, ND

Make an Offer

2024-09-04 22:31:06

Saturn motor and trans.

I have a 1.9L saturn engine and auto. transmission for sale out of a 93-94 saturn sl1. Will fit other year sl's. Motor has a knock in it (could just be out of time?) and trans. is just fine. Already

Parts & Accessories - Linton, ND

$150

2024-09-04 20:20:14

new 10" clutch kit for ford 10 spline 3 arm borg and beck style. Greaseable throw-

out bearing i think shaft is 1 1/16" spline o.d.

Parts & Accessories - Dickinson, ND

$70

2024-09-04 20:19:36

427 truck block,tall deck bare block with main caps std bore..also 454 2 bolt main

bare block..both $500

Parts & Accessories - Dickinson, ND

$500

2024-09-04 19:55:58

2017-2019 GM HD Truck Cognito Front drive shaft.

Eliminates the vibration when vehicle is lifted. Sold truck, no longer need. About 3k miles.

Parts & Accessories - Bismarck, ND

$350 OBO

2024-09-04 11:47:26

2 Photos

Subaru STI strut brace.

Imported from Japan, had it on my 2001 STI Forester. Not sure what else it will fit, you are welcome to check the placement on your vehicle before purchase. Will be moving

Parts & Accessories - Minot, ND

$150

2024-09-03 21:24:22

2 Photos

Chevy Transfer case. Late 90s-early 2000s. From a 02 Chevy suburban but will

fit others. Also have a core transmission 4L60E

Parts & Accessories - Cartwright, ND

$400

2024-09-03 17:56:00

3 Photos

2001 Ford explorer selling parts off it

2overnightFord explorer selling parts off it,cash only,no emails, 663-7293, moter gone,was roll over, radiator and fans,ft and rear drive shaft,fuel tank

Parts & Accessories - Huff, ND

$450

2024-09-03 17:47:21

3 Photos

Wiseco Piston kit for Honda/Acura K566m815ap

Here is a set of new Wiesco Pistons with rings and pins. they are for 81.5mm Bore. 1990-2001, Honda/Acura B16a, B17,B18a/b motors also some other

Parts & Accessories - Minot, ND

$600

2024-09-03 17:39:07

2 Photos

2002 sunfire selling parts

bad moter,auto,no emails,no title,663-7293,cash only,no fenders,no drivers door

Parts & Accessories - Huff, ND

$100 OBO

2024-09-03 11:12:30

6 Photos

Reman 350 / 5.7 chevy Engine. Turn key

Up for sale is a chevy 350/5.7 engine. Completely rebuilt, 0.20 oversize bore, .010-.010 crank all top of the line parts. This is a 1993 engine swapped to a carb. Mild cam, hi-rise with Edelbrock

Parts & Accessories - Dunseith, ND

$3,695

2024-09-03 10:49:45

2 Photos

New idle air control valve for the following models.

OEM / Interchange Numbers: 17112966, AC124, A95267, 56192, 958079, 217428. Item For 1995 Chevrolet Blazer For Chevrolet Lumina 1996-1997 For

Parts & Accessories - Bismarck, ND

$10

2024-09-03 08:28:37

9 Photos

2000-2005 Impala, MonteCarlo, Lumina Sub Frame # 10331128

We have up For Sale a used sub frame / K frame came off a 2001 Impala in very good condition, will fit 2000-2005 Impala, MonteCarlo, Lumina.

Parts & Accessories - Inkster, ND

$500

2024-09-03 08:01:33

3 Photos

New in the box connecting rods. These are Maxspeeding performance rods. They come

with Arp bolts and pin bushings. They are roughly a 18mm pin and 40mm bottom. Bought for a project that did not get

Parts & Accessories - New England, ND

$250

2024-09-03 08:01:31

Honda remaned engine...ready to install!!!

Early 80's Honda engine.It is a completely remaned.Engine has all new internal parts.It also has a new cylinder head.Its complete with everything on it.Also have the clutch,alternator,starter, and

Parts & Accessories - New England, ND

$750

2024-09-03 06:13:06

3 Photos

1981 GMC Motor 366 , with 4-barrel Holly. Motor only has 20000 miles on her .Hav

1981 Chevy Motor 366 , with 4-barrel Holly. Motor only has 20000 miles on her .Have several videos of motor running or hear it run .

Parts & Accessories - Minot, ND

$1,600

2024-09-02 23:40:46

New Bendix Air Brake Foot Valve

I have an extra brand new brake valve that I'm not going to use. It is a Bendix T-290181-E. $50

Parts & Accessories - Garrison, ND

$50

2024-09-02 13:09:45

16 QT oil drain pan

Drain pan and oil storage unit. Everything works (seals & caps) Oil filter wrench included Please text if interested

Parts & Accessories - Mandan, ND

$20

2024-09-02 13:09:28

Oil drain pan for motorcycles

Oil pan for motorcycles Low profile oil pan for draining and storage of oil for transporting. In excellent condition. Works well plus seals and caps are good. Please text if interested.

Parts & Accessories - Mandan, ND

$20

Search "it" only in Parts & Accessories, Tires & Rims

Try searching for "it" in titles only to limit your results

Customize your Search Radius & Location

More Links

My Links

Automobiles it

More on BisManOnline

HELP & SUPPORT

Customize your Search Radius & Location

More Links

My Links

Automobiles it